Schlage Connect Door Lock Wont Connect To Wink Hub

When you have successfully connected your devices you will see a flashing green check mark on the lock.

Schlage connect door lock wont connect to wink hub.

From there enter in one of the user codes. In the new app click your hub from your dashboard. It began to initialize and then got stuck and never finished. To sync your schlage connect smart deadbolt with z wave plus to your wink hub open the wink app on your mobile device and follow the app s instructions.

Make sure the wink hub wink hub 2 is blinking a blue light then press the 0 button on your lock. The keypad should light up. Congratulations you are connected to your schlage touchscreen deadbolt. Start by opening up the door keeping it unlocked and press on the schlage button at the top of the keypad.

I tried several more times and no luck. Schlage lock won t connect to hubitat or wink. The lock will blink an orange light for a few seconds then you will get a green check mark on the lock as well as a green flash of light on your wink hub wink hub 2. I ran a exclusion and it did pick up the lock and removed the unknown device.

Because the schlage connect is powered by z wave you need to pair it with a smart home hub like wink to extend communication with your home s wi fi. Then run the pairing command on your lock. I have reset the locks the hub is within a foot when i try to pair i have a zwave device 3 feet away that is paired new batteries in the locks uninstalled and reinstalled the new st app tried with new and old st app excluded get notification on app it worked and lock shows green check included lock. I talked to wink and went through troubleshooting to no luck.

The wink app will also indicate that it has found the lock. They suggested contacting schlage which is a joke. My app only shows one lock. I tried moving my schlage lock from my wink hub over to my hubitat.

Get instant notifications whenever the door is unlocked. They have yet to suggest anything to try. This allows you to communicate with your lock via the wink app when you are remote. In the top right hand corner there s 3 dots click that and choose z wave exclusion.

I went and replaced the lock thinking something went wrong with it but after installing a new lock it still wont connect. And you may be able to completely unpair your lock which allows the lock to be paired again with your hub. I cannot set up the house lock and hub. The lock should now be ready to go for manual usage.

Connect it to your smarthome hub. None of the 3 locks will connect. Use amazon alexa to control your lock with your voice. List of products included in this video.